Stainless Steel Geosub Pump

The Stainless Steel (SS) Geosub Pump is a low voltage, stainless steel, submersible groundwater sampling and purging pump. It has a number of attributes which make it the ideal environmental groundwater sampling and purging tool.

Contact Van Walt

Advantages

The SS Geosub pump is powered by DC voltage making it very safe to use. It is suitable for continuous operation and is tolerant of sediments, except clay. The pump is capable of impressive flow rates and will serve well as a combined sampling and purging pump to depths up to 45 meters

  • Low Voltage DC power – safer than high Voltage AC pumps
  • Dry run cut off can save energy
  • Pump is suitable for continuous operation
  • The pump is rated at 2000 hours of use in CLEAN water. In common with other impeller type pumps, sediments can cause damage and reduction in pump flow rate performance is an early indicator
  • Pumps to depths of 45m in 2′′ diameter or larger wells
  • Step-less control for flow rates from a trickle to 13 litres per minute
  • Pump is stainless steel so can be de-contaminated
  • Up to 80 different well settings can be stored and programmed

Stainless Steel Geosub Pump

Call Van Walt
+44 (0) 1428 661 660 Call Van Walt
+64 (0)3443 5326 Call Van Walt
+27 21 518 1347

Stainless Steel Geosub Pump Equipment Options:

Specifications

Technical specifications
Pumps down to
45m
Diameter
42mm
Product material
Stainless steel
Tubing
10 x 12 Polyethylene 75m roll
Flow rate
Up to 13 Litres per minute
Power Supply
110V Generator

Accessories

Polyethylene Tubing
Hallmarked and carries our QA plus stamp of purity and cleanliness. It is ideal for sampling for trace metal; Hydro-carbons; Volatiles and Macro-parameters analysis.
Disposable In-Line Filters
On site in-line filtration is required when sampling or monitoring groundwater for contamination and metals. These In-Line Filters have 0.45 micron pores.
Disposable In-Line Large White Filter
On site in-line filtration is required when sampling or monitoring groundwater for contamination and metals. These In-Line Filters have 0.45 micron pores. It is more economical to use the larger filters when the water is dirty. The filters are hallmarked and the larger filters have been tested for over 100 parameters. High capacity filter area of 700cm2
Disposable In-Line Medium Blue Filter
On site in-line filtration is required when sampling or monitoring groundwater for contamination and metals. These In-Line Filters have 0.45 micron pores. It is more economical to use the larger filters when the water is dirty. The filters are hallmarked and the larger filters have been tested for over 100 parameters.

Resources

Video

Manuals & Downloads

Related Equipment

HydraProbe – Soil Moisture Probe

The HydraProbe – Soil Moisture Probe from the Stevens Water range. A rugged soil moisture sensor with patented technology. Provides continual and consistent accuracy to measure the three most significant...

Read More

Gas Vapor Probe Kit with Dedicated Tips

The Gas Vapor Probe Kit with Dedicated Tips is excellent for monitoring and sampling hydrocarbon spill sites. It uses a slide or electric rotary drive hammer drill to insert a stainless steel tip to the...

Read More

Single Gouge Auger Open End

Read More

Have a question for Van Walt?

Please complete the form below; a member of our team will contact you shortly

Oops! Something went very wrong. Please refresh and try again...
+44 (0) 1428 661 660 +64 (0)3443 5326 +27 21 518 1347