When it comes to accuracy – you can count on Van Walt Ltd

September 15, 2014

But on this occasion we need the help of all you professionals working out in the field. Please read on…

A question that has been keeping me awake at night: Is your manual dip correct?

This has come about In the light of higher accuracy water level sensors we have recently launched from Instrumentation North West (INW) – AquiStar® Smart Sensors. These vented sensors have a “typical” accuracy of 3mm making them one of the most accurate transducer now available for environmental research. They are particularly appropriate for measuring surface water fluctuations.

However, before deployment they require a manual dip to water to establish a reference point from which to analyse the data. Currently this is done with a water level dip meter but this is prone to a number of problems:

1. The measurement is only as good as the operator on the day
2. Often the tape measure is a little bowed and this affects the readings
3. Sensors are frequently deployed within a stilling well at an angle from the lake or river shore. In the absence of an accurate inclinometer (and the application of Pythagoras’ theorem) this manual water level will throw up some inaccuracies.
4. In measurements of elevation of land a differential GPS system is used. This is a skilled job and the equipment is very expensive so probably not an option?

Contrary to absolute loggers (like Diver Level Loggers), INW sensors require a manual dip at the start of the deployment but using a poor manual dip will substantially increase the measurement inaccuracy.

So how do we get this datum? In my opinion it may be best to enter a “0” manual dip and insert the datum at a later point but of course we’d still be left with the value of the datum, but this could be obtained anytime in the deployment time sequence.

The question remains: How do we get the (accurate) datum? Can we work without it? (This may be the best route). I’d really like to hear your thoughts on this conundrum – post a reply below or email me on vincent@vanwalt.com.

Vincent van Walt

You might also be interested in...

Spot measurement v. continuous environmental monitoring

August 25, 2023

Environmental monitoring has developed considerably over the years. From the time when a consultant went out monthly or quarterly with a dip tape to monitor the groundwater level in a borehole, wind forward...

Read More

Measuring Nitrates (NO3, NO3-N) in the field

June 20, 2023

The interest in Nitrates is nothing new. One way or another we have been measuring them for half a century.

Read More

Save time, save money, save effort, get better results – use low-flow sampling…

June 1, 2023

A client recently contacted me to ask if we can repair their high flow purge pump and or sell then a new one.  They were using it for (among other applications) to purge a 70m deep bore 3 times for a...

Read More